Common problems associated with abrasive belt
Q: 1 stainless steel plate with abrasive shock pattern is how to solve?
Answer: to see is not abrasive belt to the surface of the stainless steel brings shock pattern, if uneven and would also be possible to stainless steel plate brought shock pattern, if the belt is, the solution is as follows:
1, the interface for the S belt, absolutely can not use lap.
2, S then also to the formation of the word, otherwise it will cause the earthquake
3, the uneven size of abrasive grit, solution: change the uniform sand belt.
4, if the oil is brushed, recommend the use of silicon carbide abrasive belt
5, the belt can not appear trumpet, treatment methods: to go before the belt ends are aligned, if there are no creases in the middle, under normal circumstances, new belt up the use of time, there are so many boards will shock pattern, sand a few pieces of board after going to be okay.
Ask 2:. belt poisonous furniture factory
Answer: the furniture factory general belt with quartz sand as grinding material, quartz sand itself is not toxic.
Q: why not stick 3 belt.
Answer: 1, used the,
2, the time is long, the rubber aging,
3, the paste surface is not smooth,
4, stick when pulling on the rubber, the molecular structure changes, lost the ability of cement.